AD/X-TS/6 - Main Undercarriage Attach Bracket

COMMONWEALTH OF AUSTRALIA (Civil Aviation Safety Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY

SCHEDULE OF AIRWORTHINESS DIRECTIVES

AIRWORTHINESS DIRECTIVE

For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Eagle X-TS Series Aeroplanes

AD/X-TS/6 Main Undercarriage Attach Bracket 10/2004

TX

Applicability: All Model X-TS, X-TS 150, and 150B aircraft.

Requirement: Inspect in accordance with Eagle Aircraft Service Bulletin 1123 original issue, or later revision approved by Malaysia DCA.

If adjoining plates on the undercarriage attach bracket are not welded, before further flight, replace the attach bracket.

Compliance: Before further flight after 18 August 2004.

This Airworthiness Directive becomes effective on 18 August 2004.

Background: A report was received of cracking on a main undercarriage attach bracket; discovered during a routine 100 hourly inspection. Investigation revealed the cracking was initiated by a high stress concentration, which resulted from a missing weld on adjoining plates on the undercarriage attach bracket.

David Villiers

Delegate of the Civil Aviation Safety Authority 17 August 2004

The above AD is notified in the Commonwealth of Australia Gazette on 18 August 2004.

Page 1 of 1