Electricity Safety (Cathodic Protection) Regulations 2019

This regulation applies to a registered cathodic protection system with a total output over 2 amperes, registration of which is due to cease under regulation 10(2)(a).

The owner of a cathodic protection system to which this regulation applies may apply to Energy Safe Victoria to register the system, for a further period of registration, at any time before the registration of that system ceases under these Regulations.

The application must—

be in writing and in the form approved by Energy Safe Victoria; and

include the name, address and ABN (and, if applicable, the ACN) of the owner of the cathodic protection system; and

include the name and ABN (and, if applicable, the ACN) of the operator or proposed operator of the cathodic protection system (if the owner is not or will not be the operator); and

indicate the proposed maximum operating current of the cathodic protection system; and

be accompanied by—

a map showing the location of the system, the metallic structure it is intended to protect and all metallic structures likely to be affected by the proposed system; and

drawings detailing the proposed system; and

a report on all consultations carried out between the applicant and the owners of metallic structures likely to be affected by the cathodic protection system including—

the names, addresses and telephone numbers of the owners of metallic structures consulted; and

the dates each of the owners of metallic structures were consulted; and

any known objections to the registration of the system; and

the relevant registration fee set out in the Schedule 1.